New: design your building in 3D and get a build sheet with your concrete and anchor needs.design your building in 3D.

Try the designer

RV & boat covers

Tall steel covers for campers, boats and trailers. Delivered and installed.

Tall legs and long bays keep sun, rain and leaves off your RV or boat. Leave it open, add side panels or enclose it as an RV garage, and a building specialist will call with your price.

Leg height
Up to 20'
Lengths
Up to 100'
Sides
Open, paneled or enclosed
14' 18'
ModelRV cover W × L × H18' × 41' × 14' RoofVertical, 3:12 SidesGable ends, top panels
  • Delivery & install included on most buildings
  • Wind & snow certified options for your county
  • Permit check before any deposit
  • Financing & rent-to-own available

Popular RV and boat cover sizes

Common starting points. Open any of them in the 3D designer to change the length, leg height, sides and colors, or send it to us as it is for a price.

  • 10' 12'

    Boat cover

    12' × 26' × 10'

    • Covers a boat on its trailer
    • Gable panels on both ends
    • 3' panels along the top of each side
  • 14' 18'

    RV cover

    18' × 41' × 14'

    • 14' legs clear most motorhomes and fifth-wheels
    • 41' long covers a 35' RV with room to spare
    • Gable panels and top side panels
  • 16' 20'

    Tall RV cover

    20' × 46' × 16'

    • 16' legs for tall fifth-wheels and toy haulers
    • 46' long for longer rigs
    • Gable panels and top side panels
  • 16' 24'

    Enclosed RV garage

    24' × 51' × 16'

    • One 14' × 14' roll-up door
    • Fully enclosed walls and ends
    • Walk-in door and window on the side

Covering something else, like a tractor or hay? See carports and equipment covers

3D RV cover designer

Design your RV cover in 3D

It opens as an 18' wide cover with 14' legs, gable panels on the ends and 3' panels along the top of each side. Change the length and height to fit your rig, open or close any side, and pick your colors.

Drag to spin · Pinch or scroll to zoom

Start from

Roof style

Width is the end with the peak. Leg height is measured to where the roof starts.

Get the height and length right

Measure before you order. Most mistakes with RV covers come from guessing the height.

  • Measure to the highest point

    Include the air conditioner, antenna, vents and ladder. Then add at least a foot for the leg height, measured to where the roof starts.

  • Add length at both ends

    Give yourself several feet beyond the hitch and the rear bumper so the ends stay covered when rain blows in.

  • Enclosed? Check the door

    An RV garage needs a roll-up door tall enough for your rig, and legs 2' taller than the door for doors 12' and larger.

    Door headroom table

What will it sit on?

Open buildings can go on concrete, asphalt, gravel or level ground. Each surface uses a different anchor, and every one needs to be level within 3". Enclosed buildings do best on a concrete pad.

  • Concrete

    Wedge anchors

    One at each leg, within 6" of the leg and at least 3" from the slab edge. Most installers want the pad 6" larger than the frame, 4" thick at 2,500 PSI.

    Concrete calculator
  • Asphalt

    Asphalt anchors

    Set along each base rail, about 10–15' apart.

  • Gravel

    Earth auger anchors

    Along each base rail, about 10–15' apart, into 4–6" of compacted crushed stone.

  • Dirt or grass

    Earth auger anchors

    Along each base rail, about 10–15' apart, into firm ground that's cleared and compacted.

These are planning guides. Your installer confirms the final anchor layout for your wind and snow rating.

RV cover questions

Don't see yours? Call (770) 828-4626 and ask.

How tall should my RV cover be?

Measure your RV to its highest point, including the air conditioner and antenna, and add at least a foot. 14' legs clear most motorhomes and fifth-wheels; taller rigs need 16' or more.

Do the side panels matter?

Gable panels on the ends and 3' panels along the top of the sides add shade and rain cover while leaving it open to back in. You can also fully enclose it as an RV garage with a roll-up door.

Can it go on gravel?

Yes. RV covers often sit on compacted gravel with earth auger anchors along each base rail. An enclosed RV garage does best on a concrete pad.

Do I need a permit?

Many counties require one. We check your county's requirements before you pay a deposit and can provide certified drawings for your permit application.

Get your price

Send us the basics and a building specialist will call you with a price, usually the same business day.

  1. We review your size, location and wind or snow needs.
  2. We call to confirm details and answer questions.
  3. You get an itemized quote and drawing to review.

Prefer to talk now? (770) 828-4626

Or email contact@workenstructures.com

We only use your information to prepare your quote.

Call Get a quote